View Neighbor Discovery Inspection Statistics on a Port

About this task

Use this procedure to view the Neighbor Discovery inspection statistics on a port or set of ports.

Procedure

  1. Enter Privileged EXEC mode:

    enable

  2. Display ND inspection statistics on a port or a set of ports:

    show ipv6 fhs statistics nd-inspection {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Variable Definitions

The following table defines parameters for the show ipv6 fhs statistics nd-inspection command.

Variable

Value

{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:
  • a single slot and port (slot/port)

  • a range of slots and ports (slot/port-slot/port)

  • a series of slots and ports (slot/port,slot/port,slot/port)

  • all ports on the same slot (slot/all)

  • all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.